Speaker Connections; Input Signal Connections; Amplifier Connections - Dual XPR522 Installation & Owner's Manual

Speaker Connections

Connect speaker wires observing
polarity. The minimum impedance
load for the XPR522 or XPR540
is 2 ohms stereo and 4 ohms
bridged. Use of loads lower than
these is not recommended and
may cause amplifier damage. The
XPR522 and XPR540 can be wired
for stereo, bridged or stereo/
bridged simultaneous operation.

Input Signal Connections

Low Level Input (RCA)
Low level (RCA) input signal is preferred for best performance. Typical trunk-mount
amplifier installations require a 17-20 foot RCA cable. Most trucks and under-seat
applications require a 6-9 foot RCA cable. Using twisted pair construction RCA cables will
minimize noise.
CAUTION
Do not use both low and high level inputs at the same time - connect only one or the other.

Amplifier Connections

2 Speakers (stereo)
Typical Stereo Wiring
(2 ohms minimum)
XPR522 speaker connections shown
High Level Input (Speaker Wire)
High level inputs should only
be used when RCA outputs are
not available from the head unit.
Connect the head unit speaker
outputs to the high level input
connector as shown below. The
black wire (signal reference ground)
may or may not require a connection
to chassis ground - depending on
your particular installation.
HI-LEVEL INPUT CONNECTION
Subwoofer (mono)
Typical Bridged Wiring
(4 ohms minimum)
Grey = Right (+)
Grey/Black = Right (-)
Black = Ground
White/Black = Left (-)
White = Left (+)
7