Using The Mobile Charger - Honeywell Dolphin 7850 User Manual

Using the Mobile Charger

The Mobile Charger connects the terminal to a vehicle power source. This cable powers the terminal and
charges the main battery pack.
Using the Mobile Charger Inside a Vehicle
Using the Mobile Charger in combination with the Mobile Mount powers and secures the terminal inside
a vehicle.
1. Insert the terminal into the Mobile Mount.
2. Install the Mobile Mount inside the vehicle.
3. Plug the Terminal Connector
bottom panel of the terminal.
4. Tighten the Jackscrews
5. Plug the Vehicle Power Adapter
Note: Dolphin terminals contain an intelligent battery charging system that monitors the charging of the battery pack
to protect the battery from damage by overcharging if left connected to a charging peripheral indefinitely.
Terminal Connector
Terminal
Connector
The terminal connector connects the communication cable to
the I/O connector (see
terminal.
Jackscrews
The pins in this connector work only with the I/O connector on
the terminal.
Jackscrews
The jackscrews secure the terminal connector to the I/O
connector on the terminal.
Once the terminal connector is plugged into the I/O connector
on the bottom panel of the terminal, turn both jackscrews to the
right to secure the connection.
Vehicle Power Adapter
The vehicle power adapter plugs into a standard vehicle power
source and converts voltage to the 9.5 volts DC required by the
terminal.
Vehicle
Power
Adapter
(see page 12-3) of the Mobile Charger into the I/O connector on the
(see page 12-3).
(see page 12-3) into the vehicle power outlet.
I/O Connector on page 3-9) on the
12 - 3