Gear Case - Echo SRM-2400SB Operator's Manual

99944200620
1. Remove right ProPaddle sweeper drum assembly and gear
housing shaft alignment screw (A).
2. Loosen gear housing shaft clamp bolt (B).
3. Remove drive shaft assembly from gear housing.
4. Pull flexible cable (C) from gear housing end of drive shaft
housing, wipe clean, and re-coat with a thin coating [15 ml
(1/2 oz.)] of POWER BLENDX
5. Slide the flexible cable back in the drive housing. DO NOT
get dirt on the flex cable.
6. Insert tip of flex shaft into gear housing drive socket.
7. Align hole in gear housing with positioning hole in shaft (D).
8. Insert lower driveshaft tube (end without model
number/coupling alignment decal) into gear housing shaft
mount.
9. Install and tighten alignment screw (A).
10. Tighten gear housing shaft clamp bolt (B).
11. Make sure tube protector is positioned against gearcase
housing.
Note: Tube protector may be turned or reversed if worn.
12. Reinstall right ProPaddle sweeper drum assembly and
secure with split pin.

Gear Case

The gearcase should be filled with 60 cc (2.0 fl.oz.) of Mobil SHC634 Synthetic Gear Oil. A maximum of
75-80 cc can be used, but never to exceed 80 cc. Operation with excessive oil level will result in high
operating temperatures. Do not overfill! Replacing the gearcase oil
BURN DANGER! The gearcase will be extremely hot after use!
X7532093905
© 10/2013 ECHO Inc.
TM .
MAINTENANCE
C
A
D
B
C
C
B
A
17