. By carefully reading this owner's guide prior to using your system, you will maximize the use of this system and its features . Additional or replacement copies of this guide can be printed by accessing the Clarion internet website at www .clarion .com . System Maintenance The system requires no specific main te nance .
FCC/ID Notice This device complies with Part 15 of FCC rules . Operation is subject to the following two con di tions: (1) This device may not cause harmful interference, and (2) This device must accept any in ter fer- ence re ceived, including in ter fer ence that may cause undesirable op er a tion .
Transmitter Functions The receiver uses a computer-based learn routine to learn the trans mit ter buttons . Standard configuration Button The door lock is controlled by pressing Button and HOLD The remote panic is controlled by pressing and holding . Press �������...
mode . Buttons ������� When simultaneously pressed these buttons control the rear win- dow defogger during remote starting . ������� Using Your System Warning! Safety First The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this ■...
Page 8
THE VEHICLE . ALL DOORS LEADING FROM ADJACENT LIVING AREAS TO THE ENCLOSED OR PARTIALLY ENCLOSED VEHICLE STORAGE AREA MUST AT ALL TIMES REMAIN CLOSED . These precautions are the sole responsibility of the user . Use of this product in a manner contrary to its intended mode ■...
MODE OF OPERATION . OPERATING THE remote start SYSTEM UNDER THESE CONDITIONS MAY RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY . YOU MUST IMMEDIATELY CEASE THE USE OF THE UNIT AND SEEK THE ASSISTANCE OF AN AUTHORIZED UNGO DEALER TO REPAIR OR DISCONNECT THE INSTALLED remote start MODULE .
to check with the installer for the location of the Valet button . To disable the starter kill without a remote: If your remote transmitter is lost or damaged, you can manually override the starter kill. To do this, you must have the ve hi cle's igni- tion key and know where the Valet button is located.
Remote start This feature allows you to remotely start and run your vehicle for a pro gram ma ble period of time . This makes it possible to warm up the engine, as well as adjust the interior tem per a ture of the ve hi cle with the climate control system .
While the vehicle is running during remote start operation, the system will monitor the ve hi cle and will automatically shut down the engine if the system receives any of the following shut-down inputs: The brake pedal is pressed . ■...
timer mode is cancelled . Press Timer mode buttons . The vehicle will confirm with 4 parking light flashes . The car starts and runs for the programmed duration, unless shut down by the remote start button . If shut down with the remote start button the system will remain in timer mode .
Rear defogger To turn the rear defogger output OFF: Simultaneously press & release the buttons ������� on the remote control . The lights will flash 2 times . The rear defogger output will no longer activate when the vehicle is remote started . �������...
Page 15
To perform Valet Take-Over: Before turning off the engine, press and release once within 2 seconds (or press and release the optional Mo men- tary switch) . Turn the ignition key to the OFF position . (The engine will stay running .) The engine will run until the pre-pro- grammed time elapses or a shut-down input is received .
Programming Options Programming options control your system's normal, operational set-up . Most options do not require additional parts, but some may require installation labor . The following is a list of the programmable options, with the factory settings in Bold . 12, 24, or 60 minute run time .
Glossary of Terms Control Unit: The “brain” of your system . Usually hidden under- neath the dash area of the vehicle . It houses the microprocessor which monitors your vehicle and controls all the system func- tions . Transmitter: A hand-held, remote control which operates the vari- ous functions of your system .
Quick Reference Guide To lock the doors using your remote Press for one second to lock the doors . The parking lights ■ flash once to confirm the doors are locked . To unlock the doors using your remote ■ To unlock the doors, press for one second .
Clarion. If it becomes necessary to send the product or any defective part to Clarion, the product must be shipped in its original carton or equivalent carton, fully insured, with shipping charges prepaid.
Page 22
ALSO HAVE THE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE. Should you have any difficulties with the performance of this product during warranty, please call: 1-800-GO-CLARION or visit your local Ungo Pro Security dealer. You may also contact the National Service Manager at the following address below for additional service help you may need.
Page 24
Get Started Get Protected Ungo ProSecurity 6200 Gateway Drive. Cypress, CA 90630 800-GO-CLARION...