Installing The Car Seat - Graco deluxe series Owner's Manual

Only use this car seat on vehicle
seats with seat backs that lock in
place. Seats without latches, that fold
forward or pivot freely should not be
used.
Only use this car seat on vehicle
seats that are fully padded and are
free of sharp objects.

Installing the car seat

After fitting the harness to your baby
and determining which vehicle seat
location is best, you are ready to
install your car seat. The installation
instructions vary depending on
whether or not you are using the
base. Refer to the proper section
below:
Step 1.
Place your car seat (or base without
the seat) into a forward-facing vehicle
seat with no air bag and with an
approved type of seat belt. Face your
car seat or base toward the rear of
the vehicle. Check that the car seat
handle is up.
DO NOT use car seat in a vehicle
with the handle in the sitting
(down) position.
NEVER face this car seat forward.
Serious injury or death can result
if this car seat is used facing
forward.
26