2 electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Care and cleaning Control panel What to do if… First use Technical data Daily use Installation Helpful hints and tips Environmental concerns Subject to change without notice...
Page 3
3 • It is dangerous to alter the specifications Care and cleaning or modify this product in any way. Any • Before maintenance, switch off the appli- damage to the cord may cause a short- ance and disconnect the mains plug from circuit, fire and/or electric shock.
4 electrolux Environment Protection ance shall be disposed according to the applicable regulations to obtain This appliance does not contain gasses from your local authorities. Avoid dam- which could damage the ozone layer, aging the cooling unit, especially at the in either its refrigerant circuit or insula- rear near the heat exchanger.
5 DAILY USE Movable shelves The walls of the refrigerator are equipped with a series of shelves support so that the shelves can be positioned as desired. Some shelves must be lifted up by the rear edge to enable them to be removed.
6 electrolux Air circulation gradually pull the shelf in the direction of the arrows until it comes free, then reposition The refrigerator compartment is equipped as required. with a D.A.C. (Dynamic Air Cooling) fan which enables rapid cooling of foods and a Important! Do not move the big lower door more uniform storage temperature.
7 aluminium foil or polythene bags to exclude • If you want to check the temperature of as much air as possible. food stored in the refrigerator, place a Milk bottles: these should have a cap and glass of water centrally in the cabinet,...
8 electrolux Important! Do not use detergents or refrigerator compartment channel to pre- abrasive paste as these will damage the vent the water overflowing and dripping on- paint, or stainless steel anti finger print to the food inside. coating. After cleaning, reconnect the equipment to the mains supply.
Page 9
9 Problem Possible cause Solution The compressor runs The Temperature regulator may Set a warmer temperature. continuously. be set incorrectly. The door is not closed correctly. Refer to "Closing the door". The door has been opened too Do not keep the door open longer frequently.
10 electrolux Problem Possible cause Solution The lamp does not work. The lamp is defective. Refer to "Replacing the lamp". Door interferes with ven- The appliance is not levelled. Refer to "Levelling". tilation grill. Misaligned door. The appliance is not levelled.
Page 11
11 wall unit, the minimum distance between 3. Remove the transport support from the the top of the cabinet and the wall unit lower hinge (some models). must be at least 40 mm . Ideally, however, Important! Some models are fitted with a the appliance should not be positioned be- silencing pad under the cabinet.
Page 12
12 electrolux Install the spacers on the back side of the 4. Unscrew the hinge (B1) and remove the panel. cover plate (B2) and the support (B3). Remove the cover (B4) on the opposite side and install the support (B3) the cov- er plate (B2) and the hinge (B1).
13 7. Unscrew the handle. On the opposite 9. Put the appliance in position. side remove the hole covers by driving a Warning! Reposition, level the 3–4 mm drift or drill into them. Install the appliance, wait for at least four hours handle.