Prior To Using For The First Time; Setting The Water Softener - AEG FAVORIT 44050 Vi User Information

Prior to Using for the First Time

1. Set the water softener
2. Fill up with dishwasher salt
3. Fill up with rinse aid
3
If you wish to use 3in1 detergent, do the following:
– First read the section "Using 3in1 detergents".
– Fill the salt container with dishwasher salt.
– Set the softener unit to its lowest setting.
– Deactivate the rinse aid dispenser. For dishwashers where the rinse
aid dispenser cannot be deactivated, set the rinse aid dosage to "I".
– Before the start of the dishwashing cycle put 3in1 detergent in the
detergent dispenser.
– The drying result may be affected.

Setting the Water Softener

The water softener must be set manually and electronically:
3
To avoid scale deposits on the dishes and in the dishwasher, the dishes
must be washed with soft water, i.e. water with a low lime content. The
water softener must be set according to the table to the water hard-
ness in the area where you live. Your local water company will be able
to give you information about the water hardness in your area.
The dishwasher must be switched off.
Setting manually:
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn water hardness dial on the left
wall of the dishwasher interior to O
or 1 (see table).
Setting electronically:
1. Press the ON/OFF button.
3
If the LED indicator of only one programme button is illuminated, this
wash programme has been activated. The wash programme must be
deselected:
7