Activating/Deactivating The Acoustic Signal - AEG FAVORIT 44050 Vi User Information

Setting the Amount of Rinse Aid Required
3
Only change the amount dispensed, if smears, milky spots (reduce the
amount) or dried on water spots (increase the amount) can be seen on
glasses and dishes. (See section "If dishwashing results are not satisfac-
tory".) The dosage can be set from 1-6. The dosage is pre-set to "4" in
the factory.
1. Open the dishwasher door.
2. Press the release button on the rinse
aid compartment.
3. Open the cover.
4. Set the dosage level.
5. Press the lid shut until it clicks into
place.
6. If rinse aid has leaked out, wipe it
away with a cloth.

Activating/deactivating the acoustic signal

In addition to the optical display (e.g. indicating the end of the cycle,
errors) you can also choose to set an acoustic signal.
1. Press the ON/OFF button.
3
If the LED indicator of only one programme button is illuminated, this
wash programme has been activated. The wash programme must be
deselected:
Press function buttons 2 and 3 simultaneously for approx. 2 seconds.
The LED indicators of all the buttons that can be selected will illumi-
nate.
2. Press function buttons 2 and 3 simultaneously and hold them down.
The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 3.
The LED indicator for function button 3 will flash.
The end of wash programme indicator displays the current setting:
End of wash programme indicator
is illuminated:
End of wash programme indicator
is not illuminated:
Acoustic signal activated
(factory setting)
Acoustic signal deactivated
11