Phone Initialization; Hardware Self-Test; Tftp Update Screen; Automatic Phone Initialization - Doro ip810c Manual

Phone Initialization

After your phone has been powered up, the system boots up and performs the following steps:

(1) Hardware Self-Test

A phone hardware self-test is run, all LEDs light up.

(2) TFTP Update Screen

The TFTP Update Screen allows you to update the firmware and set the phone back to
factory values.
ip810c
Warning: Use this option only when the phone is malfunctioning on reboot. All
settings will be lost and the phone is set back to factory values!
For TFTP update:
Press any key: 3
For further information read the instructions in our administrator manual.
http://www.doro.com/voipsupport/ip8X0c/

(3) Automatic Phone Initialization

The phone continues the initialization process by loading the last saved configuration.
ip810c
System booting.
Please wait...
(3a) DHCP Request
By default the phone attempts to contact a DHCP
its valid network settings, e.g. IP address, netmask, gateway, DNS server, etc. The message
"Sending DHCP request" is displayed briefly and the obtained IP address and the phone's
MAC address are displayed.
4
DHCP: Dynamic Host Configuration Protocol is a standardized protocol used by network
devices to obtain IP addresses and other parameters from a DHCP server (router etc.)
User Manual - English
ip820c
For TFTP update:
Press any key: 3
ip820c
System is booting up.
Please wait...
ip830c
For TFTP update:
Press any key: 3
ip830c
System is booting up.
Please wait...
Server in your network in order to obtain
4
1 2
ip840c
For TFTP update. Press any key:
ip840c
System is booting up. Please wait