Ducati SUPERBIKE 1198 Owner's Manual page 39

Clock setting function
This function is used to set the clock time.
E
To set the clock, select the "TIME Set" page from the menu.
From this page, if you press switch (1, fig. 10) in position B
"▼" for 3 seconds, you enter clock setting mode.
On entering this function, the message "AM" flashes on
the display: if you press switch (1, fig. 10) in position B "▼",
the message "PM" flashes on the display; pressing switch
(1, fig. 8) in position B "▼" again returns you to the previous
step (if the time is 00:00, when you switch from AM to PM
the time 12:00 will appear);
if you press the switch (1, fig. 10) in position A "▲", you pass
to the hours setting mode and the hours digits will start
flashingd. Each time you press the switch in position B "▼",
the count advances cyclically in steps of 1 hour; if you hold
the switch down in position B "▼", the count advances
cyclically in steps of 1 hour every second (when the switch
is held down continuously, the hours do not flash);
if you press switch (1, fig. 10) in position A "▲", you enter
the minutes setting mode and the minute digits will start
flashing. Each time you press the switch in position B "▼",
the count advances cyclically in steps of 1 minute; if you hold
the switch down in position B "▼", the count advances
cyclically in steps of 1 minute every second. If the switch is
held pressed in position B "▼" for more than 5 seconds, the
minutes advance by 1 every 100 ms (when the switch is held
in position B "▼" continuously, the seconds do not flash);
if you press the switch in position A "▲", the system exits
setting mode and displays the newly set time.
38
B = ON for 3 secs.
Flashing
B
Flashing
B
Flashing
B
Flashing
B
B
A
B
A
A
A
A
Flashing
A
Flashing
fig. 28