Ducati SUPERBIKE 1198 Owner's Manual page 30

LAP Memory display
Displays the data saved using the LAP function: lap time,
MAX speed and MAX rpm.
To display the saved lap times, go into the menu and select
the "LAP MEM" page.
From this menu page, if you hold pressed switch (1, fig. 10)
in position B "▼" for 3 seconds, the data for the first lap will
appear. The display will show the lap number, lap time, MAX
speed and the MAX rpm reached for the lap in question.
If you press switch (1, fig. 10) in position B "▼", the display
scrolls through the 30 lap times saved in the memory,
st
before returning to the 1
If you press switch (1, fig. 10) in position B "▼" for
3 seconds while the saved times are displayed, the display
immediately resets all the saved times. In this case, if the
LAP function was active, it is switched off automatically.
The MAX speed saved is the maximum speed indicated
on the display in Lap function.
During saving, if the MAX speed shown exceeds 299 km/h
(186 mph), the speed reached is displayed (e.g. 316 km/h).
If there is no reading in the memory, the 30 times are shown,
with the display showing "00.00.00", MAX rpm = 0 and
MAX speed = 0.
During the lap, if the engine reaches one of the two
thresholds before the rev limiter or the rev limiter itself, the
respective warning lights (10, fig. 4) come on during the
display of the saved times.
lap.
B
A
B x 19
A
A
B x 19
A
E
B
B = ON for 3 secs.
Resets lap times
in memory
B
fig. 23
29