Where To Install - Electrolux Swissline GL EWF 1082 User Information

6. Unscrew and remove two screws E using special
spanner A.
7. Unscrew and remove four screws F using special
spanner A.
8. Remove transit bar G.
9. Screw in the four screws F again.
10.Seal the two big holes using sealing caps B.
Important! Press all sealing caps B (2 off) and C
(1 off ) in firmly, so that they snap into place. (Splash
protection).

Where to install

Important! The appliance must not be used in a
room where there is a danger of frost. Frost damage
or impaired operation! Frost damage is not covered
by the warranty.
• The surface on which the appliance is to be in-
stalled must be firm and level. Do not install the
appliance on carpets or on soft floor coverings.
• The surface on which the appliance is to be in-
stalled must be clean and dry and free from cover-
ings that move, so that the appliance does not
slide.
• If the location in which the appliance is to be in-
stalled is fitted with small-format tiles, put a rubber
mat (available in the shops) under the appliance.
If the appliance is to stand on a plinth:
In order for the appliance to be secure on the plinth,
fixing plates*) must be mounted, into which the ap-
pliance is inserted.
If the appliance is to stand on floors that
vibrate, e. g. floors of wooden joists with
deal boards:
If possible, install the appliance in one corner of the
room.
1. Screw a water-resistant wooden board (at least 15
mm thick) onto at least 2 of the floor joists.
2. Affix fixing plates *) onto the wooden board, into
which the appliance is inserted.
*) The fixing plates can be obtained from the Cus-
tomer Care Department.
25