What To Do If; Remedying Small Malfunctions - Electrolux Swissline GL EWF 1082 User Information

What to do if...

Remedying small malfunc-
tions
If one of the following fault codes is displayed in the
multi-display during operation:
– E10 (Problems with water inlet),
– E20 (Problems with water drainage),
– E40 (door open),
please have a look at the following table.
When the fault is remedied, press the START/PAUSE
button.
Problem
Washing machine does not
work.
Door cannot be closed.
When a button is pressed, Err
appears in the multi-display.
E40 appears.
END indicator flashes 4x, at the
same time an acoustic signal
sounds 4x.
E10 appears.
END indicator flashes 1x, at the
same time an acoustic signal
sounds 1x.
(Problems with water inflow.)
Washing machine vibrates
when operating or is noisy.
Water is leaking out underneath
the washing machine.
Possible cause
Mains plug not plugged in or fuse not
working.
Door not closed properly.
START/PAUSE button was not
pressed for long enough.
Child safety device engaged.
The selected function cannot be
combined with the programme set.
Door is not closed properly.
Tap turned off.
Filter in the screw connection of the
inlet hose is blocked.
Water tap is blocked with limescale
or faulty.
Transit packaging has not been re-
moved.
Screw feet not correctly adjusted.
There is very little washing in the
drum (e.g., just one bathrobe).
Screw connection on the inlet hose
is leaking.
Drain hose is leaking.
Drain pump cover is not closed
properly.
Washing was caught in the door.
Emergency drain hose is leaking.
In the event of other faults (E plus a number or a let-
ter): Switch the appliance off and on again. Re-set
the programme. Press the START/PAUSE button.
If the fault is displayed again, please contact the
Customer Care Department and inform them of the
fault code.
Plug in mains plug. Check fuse.
Close door - there should be an audi-
ble click.
Press START/PAUSE button for long-
er.
Release child safety device.
Make another selection.
Close door properly. Start programme
again.
Turn the tap on.
Turn off the water tap. Unscrew hose,
take out filter and clean it.
Check the water tap and have it re-
paired if necessary.
Remove transit packaging.
Adjust feet according to the Installa-
tion and Connection instructions.
This does not affect how the machine
operates.
Tighten inlet hose.
Replace drain hose.
Close cover properly.
Load washing carefully for the next
wash.
Close off emergency drain hose prop-
erly.
Remedy
17