Basic Tv Connections; Optional, Preferred Tv Connections - GoVideo DV1140 User Manual

Connections (Continued)

Basic TV Connections

Make one of the following connections, depending on
the capabilities of your existing equipment.
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the
antenna in jack on the TV using the supplied 75-ohm
Coaxial Cable (R).
ote
If you use this connection, tune the TV to the
DVD+VCR's RF output channel (CH 3 or 4).
How to set the DVD+VCR's RF output channel
1. Set the TV to the VCR channel (3 or 4) depending
upon the selected channel.
2. When the DVD+VCR is turned off, press and hold
CH (V/v) on the front panel for about five seconds.
It will turn itself on and "RF03" or "RF04" appears in the dis-
play window.
3. Press CH (V/v) on the front panel or
remote control to change the RF output channel (CH
03 or CH 04).
4. Turn off the DVD+VCR.
Audio/Video connection
Connect the DVD/VCR VIDEO OUT jack on the
1 1
DVD+VCR to the video in jack on the TV using the
supplied video cable (V).
Connect the Left and Right DVD/VCR AUDIO OUT
2 2
jacks on the DVD+VCR to the audio left/right in
jacks on the TV (A1) using the supplied audio
cables.
ote
If you use this connection, set the TV's source selector
to VIDEO.
Rear of TV
ANTENNA
VIDEO
AUDIO INPUT
INPUT
INPUT
R
L
R A1 V
Rear of DVD+VCR
12

Optional, Preferred TV Connections

ote
You can ONLY watch and listen to DVD playback
through the connections shown below.
S-Video connection
Connect the S-VIDEO OUT jack on the DVD+VCR
1 1
to the S-Video in jack on the TV using an optional
S-Video cable (S).
Connect the Left and Right AUDIO OUT jacks of
2 2
the DVD+VCR to the audio left/right in jacks on the
TV using the supplied audio cables (A2).
Component Video / Progressive Scan connection
If your television is a high-definition or "digital ready"
z z
television, you may take advantage of the
DVD+VCR's progressive scan output for the highest
video resolution possible.
If your TV does not accept the Progressive Scan for-
z z
mat, the picture will appear scrambled if you try
on the
CH (v/V)
Progressive Scan on the DVD+VCR.
Connect the COMPONENT / PROGRESSIVE
1 1
SCAN VIDEO OUT jacks on the DVD+VCR to the
corresponding in jacks on the TV using an optional
Y Pb Pr cable (C).
Connect the Left and Right AUDIO OUT jacks of
2 2
the DVD+VCR to the audio left/right in jacks on the
TV (A2) using the supplied audio cables.
otes
Set Progressive Scan to "On" in the setup menu for
z z
progressive scan signal, see page 18.
When you use Component Video signal, set
z z
Progressive Scan to "Off" in the setup menu.
Progressive scan does not work with the analog video
z z
connections (yellow VIDEO OUT jack).
Rear of TV
Rear of DVD+VCR
COMPONENT VIDEO INPUT
AUDIO INPUT
Y
Pr Pb
R L
C
A2 S
S-VIDEO
INPUT