Gas Connection - Bosch PHW206FAU User Instruction & Installation Manual

There are two ways to carry out the connection to the main
gas line:
A. The hotplate can be connected with rigid pipe as
specified in AS5601 table 3.1.
B. Flexible Hose: If installing with a hose assembly, install
with a hose assembly that complies with AS/NZS 1869 (AGA
Approved), 10mm ID, class Bor D, no more than 1,2m long
and in accordance with AS5601. Ensure that the hose does
not contact the hot surfaces of the hotplate, oven, dishwasher
or any other appliance that may be installed underneath or
next to the hotplate. The hose should not be subjected to
abrasion, kinking or permanent deformation and should be
able to be inspected along its entire length with the cooktop
in the installed position. Unions compatible with the hose fittings
must be used and all connections tested for gas leaks.
The supply connection point shall be accessible with the
appliance installed.
WARNING: Ensure that the hose assembly is restrained
from accidental contact with the flue outlet of an under-
bench oven.
Before Leaving- Check all connections for gas leaks with soap
and water. DO NOT use a naked flame for detecting leaks.
Ignite all burners both individually and concurrently to
ensure correct operation of gas valves, burners and ignition.
Turn gas taps to low flame position and observe stability of
the flame for each burner individually and all together. Adhere
the duplicate data plate to an accessible location near the
hotplate.
When satisfied with the hotplate, please instruct
the user on the
correct method of operation.
appliance fails to operate correctly after all checks have
been carried out, refer to the authorised service provider
in your area.
It should be expressly noted that we cannot accept any
liability for direct or indirect damage caused by wrong
connection, leakage or improper installation. When being
repaired, the appliance must always be disconnected from
the mains supply; if required, notify our customer service.
In case the
10