Ford Crown Victoria Owner's Manual page 69

Driver Controls
• If the indicator light stays on constantly, programming is complete
and your device should activate when the HomeLink button is pressed
and released.
• If the indicator light blinks rapidly for two seconds and then turns
to a constant light continue with "Programming" Steps 5 through
7 to complete programming of a rolling code equipped device (most
commonly a garage door opener).
5. At the garage door opener receiver (motor-head unit) in the garage,
locate the "learn" or "smart" button (usually near where the hanging
antenna wire is attached to the unit).
6. Firmly press and release the "learn" or "smart" button. (The name and
color of the button may vary by manufacturer.)
Note: There are 30 seconds in which to initiate Step 7.
7. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLink button. Repeat the press/hold/release
sequence again, and, depending on the brand of the garage door opener
(or other rolling code equipped device), repeat this sequence a third
time to complete the programming.
HomeLink should now activate your rolling code equipped device. To
program additional HomeLink buttons begin with Step 2 in the
"Programming" section. For questions or comments, please contact
HomeLink at www.homelink.com or 1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink to accept the signal
from the hand-held transmitter.
After completing Steps 1 and 2
outlined in the "Programming"
section, replace Step 3 with the
following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the "cycling" process to prevent
overheating.
69
2007 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)