Ford Crown Victoria Owner's Manual page 58

Driver Controls
Operating the HomeLink Wireless Control System
To operate, simply press and release the appropriate HomeLink button.
Activation will now occur for the trained product (garage door, gate
operator, security system, entry door lock, or home or office lighting
etc.). For convenience, the hand-held transmitter of the device may also
be used at any time. In the event that there are still programming
difficulties, contact HomeLink at www.homelink.com or
1–800–355–3515.
Erasing HomeLink buttons
To erase the three programmed buttons (individual buttons cannot be
erased):
• Press and hold the two outside
buttons. The message CLEARING
CHANNELS will appear on the
HomeLink display.
• After about 20 seconds, the
message CHANNELS CLEARED
will appear on the display. Do not
hold for longer that 30 seconds.
HomeLink is now in the train
(or learning) mode and can be
programmed at any time
beginning with step 2 in the
"Programming" section.
Reprogramming a single HomeLink button
To program a device to HomeLink using a HomeLink button previously
trained, follow these steps:
58
2007 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)