HEAT PUMP SPECIFICATIONS
SSZ140[18,30]1AF; SSZ140241AJ; SSZ140361AH
Cooling Capacity, BTUH
Compressor
R.L. Amps
L.R. Amps
Low Pressure Switch
Open
Close
High Pressure Switch
Open
Close
Condenser Fan Motor
Horsepower
F.L. Amps
Liquid Line, Inches O.D.*
Suction Line, Inches O.D.*
Refrigerant Charge
Power Supply
(1)
Minimum Circuit Ampacity
Maximum Overcurrent Device
Electrical Conduit Size
Power Supply (Inches)
Approximate Shipping Weight
*
Up to 24' in equivalent line length
(1)
Wire size should be determined in accordance with National Electrical Codes; extensive wire runs will require larger wire sizes.
(2)
Maximum Overcurrent Protection Device: MUST use Time Delay Fuse or HACR type Circuit Breaker of the same size as noted.
NOTES:
•
Always check the S & R plate for electrical data on the unit being installed.
•
Installer will need to supply 7/8" to 1-1/8" adapters for suction line connections (4 & 5 ton units).
•
Installer will need to supply 3/4" to 7/8" adapters for suction line connections (3 ton unit).
•
Unit is charged with refrigerant for 15' of 3/8" liquid line. System charge must be adjusted per Installation Instructions Final Charge
Procedure.
•
Installation of these units requires the specified TXV Kit to be installed on the indoor coil. THE SPECIFIED TXV IS DETERMINED BY THE
OUTDOOR UNIT, NOT THE INDOOR COIL.
NOTE: This data is provided as a guide, it is important to electrically connect the unit and properly size fuses/
circuit breakers and wires in accordance with all national and/or local electrical codes. Use copper wire only.
6
18,000
24,000
9.0
12.82
48.0
58.3
22 PSIG
22 PSIG
50 PSIG
50 PSIG
610 PSIG
610 PSIG
420 PSIG
420 PSIG
1/12
1/6
0.6
1.1
3/8"
3/8"
3/4"
3/4"
140.0
160.0
208/230-60-1
208/230-60-1
11.90
17.10
(2)
20
25
1/2 or 3/4
1/2 or 3/4
199
207
30,000
36,000
14.10
16.67
73.0
79.0
22 PSIG
22 PSIG
50 PSIG
50 PSIG
610 PSIG
610 PSIG
420 PSIG
420 PSIG
1/6
1/4
1.0
1.5
3/8"
3/8"
3/4"
7/8"
185.0
210.0
208/230-60-1
208/230-60-1
18.60
22.40
30
30
1/2 or 3/4
1/2 or 3/4
219
242