Table of Contents
Advertisement
152954 73/0en
24-08-2005
What to do, when...
Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...alarm messages or code are displayed
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by:
- a continuous sequence of intermittent audible signals,
- the point-shaped optical signal on the floor beneath the
dishwasher's door is flashing (not visible if the appliance has been
installed higher up with a furniture door mounted flush).
Open the dishwasher's door, a message or a code (as indicated in the
following chart) is displayed.
Carry out the following suggested corrective actions.
Fault code / Malfunction
- In the display the
message "OPEN THE
TAP" appears
The machine does not fill
with water
- In the display the
messaqge "DRAIN
BLOCKED" appears
The dishwasher will not
drain
- In the display the code
appears
8:45
Pagina 37
Possible cause
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
The sink spigot is blocked.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Anti-flood device has
activated.
Operating instructions
Solutions
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
Check the water inlet hose
connection.
Clean out the sink spigot.
Check the water drain
hose connection.
Close the water tap and
contact your local Service
Force Centre.
37
Advertisement
Table of Contents
