Dodge 2012 Journey User Manual page 64

ELECTRONICS
Programming A Rolling Code
• For programming Garage Door Openers that were manufactured after 1995. These
Garage Door Openers can be identified by the "LEARN" or "TRAIN" button located
where the hanging antenna is attached to the Garage Door Opener. It is NOT the
button that is normally used to open and close the door. The name and color of the
button may vary by manufacturer.
• Place the ignition switch into the ON/RUN position.
• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
• Simultaneously press and hold both the Homelink button you want to program and
the hand-held transmitter button.
• Continue to hold both buttons and observe the indicator light. The Homelink
indicator will flash slowly and then rapidly after Homelink
frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.
• At the garage door opener motor (in the garage), locate the "LEARN" or
"TRAINING" button. This can usually be found where the hanging antenna wire is
attached to the garage door opener motor. Firmly press and release the "LEARN"
or "TRAINING" button.
NOTE: You have 30 seconds in which to initiate the next step after the LEARN button
has been pressed.
• Return to the vehicle and press the programmed HomeLink
the button for two seconds each time). If the device is plugged in and activates,
programming is complete.
NOTE: If the device does not activate, press the button a third time (for two seconds)
to complete the training.
• To program the remaining two HomeLink
remaining button. DO NOT erase the channels.
Programming A Non-Rolling Code
• For programming Garage Door Openers manufactured before 1995.
• Turn the ignition switch to the ON/RUN position.
• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
• Simultaneously press and hold both the Homelink button you want to program and
the hand-held transmitter button.
• Continue to hold both buttons and observe the indicator light. The Homelink
indicator will flash slowly and then rapidly after Homelink
frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.
• Press and hold the programmed HomeLink
light.
62
indicator light in view.
®
has received the
®
®
® buttons, repeat each step for each
® indicator light in view.
® has received the
® button and observe the indicator
®
®
button twice (holding
®
®