Activating/Deactivating The Inflow Of Rinse Aid - AEG FAVORIT 86470 I User Information

Setting the amount of rinse
aid required
Only change the amount dispensed, if smears, milky spots or dried on
water spots can be seen on glasses and dishes. (See section "If wash
results are not satisfactory"). The dosage can be set from 1-6. The
dosage is set to "4" in the factory.
1. Open the door of the dishwasher.
2. Press the release button on the
rinse aid compartment.
3. Open the cover.
4. Set the dosage level.
5. Press the lid shut until it clicks
into place.
6. If rinse aid has leaked out, wipe it
away with a cloth.

Activating/deactivating the inflow of rinse aid

If you press 3 in 1 button, you don't need to deactivate the inflow
of rinse aid.
1. Press the ON/OFF button.
If indicators other than the ON/OFF button are lit, a dishwashing
cycle is activated. The cycle must be deselected (RESET):
Press function buttons 1 and 2 simultaneously for approx. 2 seconds.
All other indicators will go out.
2. Press function buttons 1 and 2 simultaneously and keep them
pressed. The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 2 again.
The LED indicator for function button 2 will flash.
The multi-display will indicate the current setting:
4. Pressing function button 2 activates and deactivates the rinse aid
dispensing function.
5. Once the multi-display is indicating the required setting, press the
ON/OFF button.
The setting is now saved.
Inflow of rinse aid is deactivated
Inflow of rinse aid is activated (factory setting)
Operating instructions
BR09
11