Connecting With A Multiplexer; Updating System Software - American Dynamics VideoEdge Installation & Operation Manual

Installation & Operation Guide

3.3 CONNECTING WITH A MULTIPLEXER

3.4 UPDATING SYSTEM SOFTWARE

If the system software of the IP CAMERA needs to be upgraded, please take the following steps
to safely process it.
NOTE: Before carrying out the following procedures, please ensure the SD card is working
and the file of the system firmware is intact
1. Format an SD card using the FAT format.
2. Create a directory named LANCAM in the SD card if it does not exist.
3. Copy the file of UPDATE.BIN to the LANCAM-directory.
4. If the IP camera is running, please power it off first.
5. Insert the SD CARD into the IP camera.
6. Remove the Ethernet cable from the RJ-45 port and then power on the IP camera.
7. In 5 to 10 seconds, a message reading "UPDATE PROCESSING" will show up on the screen on
a blue background; if not, please check out steps 1 to 6 carefully or else inform your technical
support while ignoring the following steps.
8. DO NOT power off the IP camera while this update process is running until the message
"UPDATE OK RESET PLEASE" appears on the screen; it might take 15 to 30 seconds to
appear.
9. If the message "UPDATE NG RESET PLEASE" appears rather than "UPDATE OK RESET
TO LAN CAMERA VIDEO OUT BNC CONNECTOR
LAN CAMERA
IP CAMERA 1
LAN CAMERA
IP CAMERA 2
LAN CAMERA
IP CAMERA16
19