Changing The Light Bulb; Moving The Meat Drawer And Cover; Adjusting The Refrigerator Shelves; Removing Crispers And Crisper Cover - Whirlpool ET18PK User & Care Manual

Changing the light bulb... u Q the light bulb...
yY&
1. Reach behind the control console to find bulb.
2. Remove bulb.
3. Replace with a 40-watt appliance bulb.
Moving the meat drawer and cover...
PULL OUT TO THE STOP, LIFT THE
FRONT AND PULL AGAIN.
GLASS IS HEAVY.
BE CAREFUL.
Adjusting the refrigerator shelves...
Shelves can be adjusted to match the way you use
your refrigerator. Glass shelves are strong enough
to hold bottles, milk and other heavy food items.
GLASS SHELVES ARE
HEAVY. BE CAREFUL.
Removing crispers and crisper cover.
. .
To remove the meat drawer and cover:
1. Slide the meat drawer out to the stop.
2. Lift the front of the meat drawer.
3. Slide the drawer the rest of the way out.
4. Tilt the cover up at the front.
5. Lift up at the back.
6. Pull straight out.
To replace the meat drawer and cover:
1. Guide the rear hooks of cover into the slots in the
shelf supports.
2. Tilt up front of the cover until rear hooks drop into
the slots. Lower front of the cover to level position.
3. Replace the meat drawer in reverse order of
removal.
To remove glass shelves:
1. Tilt up at front.
2. Lift up at back.
3. Pull shelf straight out.
To
replace glass shelves:
1. Guide the rear hooks into the slots in the shelf
supports.
,
Tilt up front of shelf until hooks drop into slot.
Lower front of shelf to level position.
2.
REMOVE THE '
GLASS INSERT.
LIFT THE FRAME FRONT,
THEN THE BACK.
GLASS IS HEAVY.
BE CAREFUL.
To remove the crispers:
I. Slide crisper straight out to the stop, lift front, then
slide the rest of the way out.
2. Replace in the reverse order.
To remove the cover:
1. Push up glass insert from the bottom, then slide
out with both hands,
2. Lift front of cover frame and remove cover
support.
3. Lift out cover frame by pulling up and out.
To replace the cover:
1. Fit back of cover into notch supports on walls of
refrigerator, then lower front into place.
2. Replace cover support with the long tab toward
the front. NOTE: If the support needs adjust-
ment, turn base right to raise or lefi to lower.
3. Slide back of glass insert into place, then lower
front.
6