Before Using Your Refrigerator; Remove Sales Labels; Clean It; Plug Itln - Whirlpool ET18PK User & Care Manual

Before using your
refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any
inside
labels before using the refrigera-
tor. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area wrth lrqurd hand drshwashing de-
tergent before removing glue as described in
step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
.5 cm) between overhead cab
2. Clean it...
Clean your refrigerator before using it See
cleaning instructions on page 8.
3. Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
inets and the refrigerator top.
2. Allow at least an inch (2.5 cm] between the re-
frigerator condenser on the back and the wall.
3. Allow YZ inch (1.25 cm) on each side of the refrig-
erator for ease of installation.
4. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
5. If your refrigerator has an ice maker, make sure
ice maker water supply has been connected.
Refer to Installation Instructions.
1. Allow3inches(
REFRIGERATOR
3-PRONG
POWER CORD
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 11.5 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding Instruction sheet in your literature
package.
5. Level refrigerator-freezer...
II
LEVELLING SCREW
RAISE 1
USE SCREWDRIVER RIGHT TO RAISE;
TO ADJUST LEFT TO LOWER
1. To raise front, turn each screw to the right.
2. To lower front, turn each screw to the left
3. Check with level.
4