Table of Contents
Advertisement
To clean a mouse with a ball:
1. Turn off your computer.
2. Turn the mouse over, with the top side down, and look carefully at the bottom.
3. Place your hand over the retainer ring and ball 2 , and then turn the mouse
4. Wash the ball in warm, soapy water then dry it with a clean cloth. Blow air
5. Look for a build up of dirt on the plastic rollers 3 inside the ball cage. This
6. If the rollers are dirty, clean them by using a cotton swab soaked in isopropyl
7. Remove any fibers from the swab that might be remaining on the rollers.
8. Replace the ball and the retainer ring.
9. Turn your computer back on.
36
User Guide
Twist the retainer ring 1 to the unlocked position to remove the ball.
over, top side up, so that the retainer ring and ball fall out into your hand.
carefully into the ball cage 4 to dislodge dust and lint.
build up usually appears as a stripe running across the middle of the rollers.
(rubbing) alcohol. Turn the rollers with your finger and continue swabbing
them until all the dirt is removed. Be sure the rollers are still centered in their
channels after you clean them.
Advertisement
Table of Contents
