AEG ÖKO-LAVAMAT 1271 T v.i. Instruction Booklet page 51

124972910•LAVAMAT1271Tvi 29-09-1999 10:08 Pagina 51
c) Mounting the door
Fix the hinges (1) to the machine by means of the M5x8 screws (3-Fig. B).
The hinges can be adjusted to compensate for possible uneven thick-
ness of the door.
To align the door perfectly it is necessary to loosen the screw (3-Fig. B),
adjust the door and tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a mag-
netic closure of the door. To enable a cor-
6
rect operation of this device, it is necessary
to screw the counter-magnet (6) (steel disk
4
+ rubber ring) into the inner side of the
door.
Its position must correspond to the magnet
(4) on the appliance (see picture D).
8
D
If the door has to be opened from
left to right, invert the position of
6
4
the plates (7), the magnet (4) and
the plate (5) (Fig. B and E). Mount
the countermagnet (6) and the
hinges (1) as previously described. 1
5
7
Important: the plastic screw (8)
should never be loosened (Fig. B 3
8
and E).
E
2
Attention!
When the appliance is installed the power supply cable must be easily
accessible.
51