Operation - AEG Electrolux 95852 G Instruction Booklet

Operation

Hob burners control knobs
The symbols on the knobs mean that :
#
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a
pan on the pan support.
!
To light a burner:
turn the relevant knob anticlockwise to maximum
#
position (
Upon ignition, keep the knob pushed down
#
about 5 seconds. This will allow the
"thermocouple" (Fig. 1 - letter D) to be heated
and the safety device to be switched off, otherwise
the gas supply would be interrupted.
Then adjust the flame as required.
#
If the burner does not ignite, turn the control
knob to zero, and try again.
Each control knob is equipped with a pilot light
which gradually lights up according to the heat
level that you select with the control knob.
When switching on the mains, after installation
or a power cut, it is quite normal for the spark
generator to be activated automatically.
In the absence of electricity, ignition can occur
without the electrical device; in this case,
approach the burner with a flame, push the
relevant knob down and turn it anti-clockwise
until it reaches the "maximum" position.
If the control knobs become difficult to turn,
please contact your local Service Force Centre.
).
Triple crown burner
C
A - Burner cap
B - Burner crown
C - Ignition electrode
D- Thermocouple
7
A
B
D
Fig. 1