Yamaha YZF-R125 Service Manual page 65

YamahaR125.COM
1. Air filter case silencer hose
2. Wire harness
3. Battery
4. Lean angle sensor
5. Tail/brake light lead
6. Sidestand switch lead
7. Neutral switch
8. Crankshaft position sensor/stator coil lead
9. Negative battery lead
10. Rectifier/regulator
11. Ground lead terminal
12. Rear right turn signal light lead
13. License plate light lead
14. Rear left turn signal light lead
15. Wire harness (to neutral switch)
A. Fasten the wire harness at the white tape with a
plastic locking tie.
B. Fasten the license plate light lead, rear left turn
signal light lead, and rear right turn signal light lead
to the rear fender stay with plastic locking ties,
making sure to align the white tape on the leads
with the ties.
C. Route the fuel tank breather hose and coolant
reservoir breather hose so that the end of each
hose is positioned further rearward than the
sidestand pivoting point as shown in the
illustration.
D. Pass the wire harness (to neutral switch) through
the guide on the left crankcase, making sure to
align the white tape on the harness with the guide
as shown in the illustration.
– °
E. 50 90
F. 100 mm (3.94 in)
G. Fasten the sidestand switch lead at the white tape
with the holder.
H. 65 mm (2.56 in)
2-42
CABLE ROUTING