Yamaha YZF-R125 Service Manual page 57

YamahaR125.COM
1. Front brake light switch lead
2. Right handlebar switch lead
3. Throttle cable
4. Main switch
5. Clutch cable
6. Clutch switch lead
7. Left handlebar switch lead
8. Sub-wire harness
9. Horn
10. Speed sensor lead
11. Front brake hose
12. Main switch lead
13. Left headlight assembly lead
14. Right headlight assembly lead
A. Route the right handlebar switch lead to the rear
the front brake hose.
B. Route the throttle cable in front of the front brake
light switch lead.
C. Pass the throttle cable through the guide.
D. Connect the horn connectors to the horn terminals
as shown in the illustration.
E. Secure the plastic locking tie by inserting the
projection on the tie into the hole in the front brake
pipe bracket, and then fasten the speed sensor
lead with the tie.
F. Pass the front brake light switch lead between the
throttle cable and the front brake hose.
G. Fasten the left headlight assembly lead and sub-
wire harness to the right headlight body with a
plastic locking tie as shown in the illustration,
making sure to align the white tape on the lead and
harness with the tie.
H. Fasten the left headlight assembly lead, right
headlight assembly lead, and sub-wire harness
with a plastic locking tie, making sure to align the
white tape on the leads and harness with the tie.
2-34
CABLE ROUTING