Buffalo AirStation WLI-TX4-G54HP User Manual page 18

◗
Wireless Mode - The wireless mode only applies to Ad-hoc connections. If the Ethernet
Converter is making an Ad-hoc connection with an 802.11b client, then select '802.11b'
from the drop down menu. If an 802.11g client is connecting to the Ethernet Converter
then select the 'Auto - 802.11g / 802.11b' option.
◗
Basic Rates - The basic rate set only applies to Ad-hoc connections. Select the proper
rate set for the Ad-hoc client the Ethernet Converter is going to associate to. If you are
unsure, it is recommended to leave this setting set to 'Auto'.
◗
Frame Bursting - Frame Bursting technology allows for quicker wireless throughput
speeds by shortening the overhead in each wireless packet. Enabling 125* High-
Speed Mode allows for the Ethernet Converter to communication using Buffalo's 125*
High-Speed Mode technology. 125* High-Speed Mode requires a compatible Buffalo
Technology Wireless Access Point or Router, if one is not available then the device will
operate as a standard 802.11g device.
◗
Wireless Output Power - The wireless output power setting changes the power of
the Ethernet Converter's internal radio. Reducing the output power can often reduce
interference with other devices. It is recommended to leave the output power set at
100% unless interference with other networks or 2.4 GHz devices is apparent.
◗
Data Encryption - The data encryption table allows you to enter the necessary WEP
or WPA settings into the Ethernet Converter. This Ethernet Converter supports WEP
64, WEP 128, TKIP, and AES. If WEP is selected, then a WEP key or series of WEP keys
must be entered into the WEP key fi eld(s). Please select whether the specifi c key is ASCII
or HEX from the pull down list next to the key fi elds. If TKIP or AES is used, then enter
the pre-shared key in the WPA-PSK fi eld.
18
Wireless Settings