Use this guide to quickly and easily install your Wireless Ethernet Converter-g. For detailed information, refer to the User Manual on the Utility CD or refer to the Buffalo Wireless Support Web Pages. Contents ◗ 54Mbps Wireless Ethernet Converter ◗...
Ethernet port on your computer and the other end to the Ethernet Converter. Ethernet ports are usually located in the rear of the computer. Plug the AC Adapter into a wall socket surge (recommended). Connect the AC Adapter Converter.
Macintosh Setup Select Use the following IP Address. Enter 1.1.1.2 into the IP Address field. Enter 255.255.255.0 into the Subnet Mask field. Click OK. Click OK again under the Network Properties window. Open Preferences and select Network. Set Show to Built-in Ethernet Set Configure to Manually Enter 1.1.1.2 into the IP Address field.
Page 4
Step Connecting the Wireless Ethernet Converter to the AirStation. Open your Web browser 4.5 or later and enter 1.1.1.1 into the URL field. The login screen will open. Enter root as the User ID. Leave the password field blank. Click OK The main configuration screen of the 54Mbps Ethernet Converter will open.
Page 5
By accepting the default configuration settings, the Ethernet Converter Manager should discover and configure properly. For more information about configuring and operating your Wireless Ethernet Converter, refer to the User Manual on the Utility CD or the Buffalo Support Web Site: http://www.buffalotech.com/wireless/support. The Ethernet Converter will scan for available wireless networks.
Page 6
Windows Step Reset the TCP/IP settings of your computer Open your network properties. Connect Using should be set to use your active Ethernet NIC Card. Select Internet Protocol (TCP/IP). Click Properties Select Obtain and IP Address Automatically. Click OK. Click OKagain under the Network Properties window.
Page 7
Some screens may vary from those shown in this guide, depending on the operating system used. For more information about configuring and operating your Wireless Ethernet Converter, refer to the User Manual on the Utility CD or the Buffalo Support Web Site: http://www.buffalotech.com/wireless/support. OSX - Open your System Preferences and select Network.