Table of Contents
Advertisement
The hinges needed for installation and the associated screws are standard parts
(included in the delivery).
Hinged door with special handle is also available as accessorie. This must be ordered
separately:
• Hinged door set in "AEG Nexxt" design:
Accessory number 153 1295 00
The plinth area that can still be seen after
the hinged door has been installed can ei-
ther be hidden with a matching panel, or by
extending the panel of the kitchen unit that
is under the appliance.
Fitting the hinged door
Fit the two lateral bars A as shown
1.
in the figure opposite. Align bars
at the top so that the upper hole
lies over the pre-mounted aligning
disk. With a width of 568 mm first
fix the additionally supplied align-
ing disks B on the already pre-
mounted aligning disks.
2.
Screw in the bars at the top only.
3.
Stand the machine in front of the
kitchen unit into which it is to be
installed. Place cable and hoses
into the neighbouring unit.
As you push the machine in, keep
on pulling the cable and hoses
through and ensure that they do
not become kinked.
Fitting the hinged door
41
Advertisement
Table of Contents
