Adjusting The Worktop; Fitting Under A Counter; Levelling - Electrolux ESF 662 Instruction Book

Adjusting the worktop

You can move the worktop forward or backward by
25 mm in order to align the machine with other
kitchen units.
Simply unscrew the two rear retaining screws,
move the top to the required position and then
retighten the screws.

Fitting under a counter

(kitchen worktop or sink)
By removing the machine's worktop, you can install
it under a close fitting sink unit or a pre-existing
top, providing the dimensions of the recess
correspond to those shown in the picture.
Proceed as follows:
Remove the machine's worktop by unscrewing the
two rear retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting the height and
levelling with the adjustable feet. When inserting
the machine, ensure that the water inlet and drain
hoses are not kinked or squashed.

Levelling

Good levelling is essential for correct closure and
sealing of the door.
When the appliance is correctly levelled, the door
will not catch on the levelling spacers, either side of
the cabinet.
If the door does not close correctly, loosen or
tighten the adjustable feet until the machine is
perfectly level.
IN03
IN05
21
PFI38GB