Adjustment - Ryobi EDP2521L Owner's Operation Manual

TABLE ADJUSTMENT
Height Adjustment (Fig 2)
To adjust up or down , loosen the clamping lever, then
adjust the table to the desired position and re-tighten
clamping lever securely.
Tilting Adjustment (Fig 3&4)
Loosen pivot bolt. Tilt table to desired angle up to 45
and retighten bolt.
Swing 360
o
Loosen clamping lever then swing table to appropriate
position and retighten.
Rotate 360
o
Loosen clamping lever, rotate table to desired position
and retighten.

ADJUSTMENT

DEPTH ADJUSTMENT
Feed depth Adjustment (Fig 5)
Lower spindle assembly to desired depth and spin down
nut. If nut moves due to vibration, spin down second
nut and lock in position by holding the lower nut and
tightening upper nut.
Fig.2
Speed Adjustment (Fig 6)
o
Open pulley cover. Loosen shifter bar. Choose speed
for drilling operation and move belt to correct position
for desired speed. Push motor backward until moderate
belt tension is acquired. Tighten shifter bar.
Belt Tension Adjustment (Fig 7)
To gauge proper belt tension, use pressure to push
down with the thumb. Your thumb should be located
Fig.3
on the belt midway between the two pulleys. The belt
should push down no more than 13mm.
Fig.4
Page 8
Fig.5
Fig.6
13mm
Fig.7