Table of Contents
Advertisement
Attention: After having reversed the opening direction of the doors check that all
the screws are properly tightened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may
not fit perfectly to the cabinet. in that case, wait for the natural fitting of
the gasket or accelerate this process by heating up the part involved with a
normal hairdrier.
Electrical connection
Before initial start-up, refer to the appliance rating plate to ascertain if
supply voltage and current values correspond with those of the mains at the
installation location.
e.g.: AC
(i.e. 230 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps. If the socket is not
accessible once the appliance is built in, the electrical installation must include
suitable means of isolating the appliance from the mains (e.g. fuse, cut-out,
current trip or similar with a minimum contact separation of 3 mm).
Attention: The mains connection cable may only be replaced by a skilled
electrician. Please contact your dealer or our customer service department
for repairs.
Prior to Initial Start–Up
• Please clean the appliance interior and all accessories prior to initial start-
up (see section: "Cleaning and Care").
Operating and indicator panel
A.
Freezer button ON/OFF
B.
Temperature setting button (+)
C.
Temperature display
D.
Temperature setting button (-)
E.
FROSTMATIC function "on" indicator (yellow)
F.
FROSTMATIC button
G.
Alarm light
H.
ALARM OFF button
70
230 ... 240 V
230 ... 240 V~
50 Hz or
50 Hz
Advertisement
Table of Contents
