Table of Contents
Advertisement
26 www.aeg.com
2.
Adjust the by-pass adjustment screw
(A) with a thin-bladed screwdriver.
A
Change of the
type of gas
From natural
gas to liquid
gas
From liquid gas
to natural gas
3.
Attach the knob for the oven func-
tions.
4.
Light the oven burner. Refer to the
section "Gas oven cooking: Ignition
of the oven gas burner".
13.9 Anti-tilt protection
Adjustment of
the adjust-
ment screw
Fully tighten
the adjustment
screw in.
Release the ad-
justment screw
approximately
3/4 of a turn.
5.
Turn the knob for the oven functions
to the maximum position and let the
oven heat for 10 minutes.
6.
Turn the knob for the oven functions
from the maximum to the minimum
position.
Control the flame. If the flame goes out,
do the procedure from point 1 to point 6
again. There must be a small regular
flame on the oven burner crown.
The manufacturer declines liability if
you do not obey these safety meas-
ures.
13.8 Levelling
Use small feet on the bottom of appli-
ance to set the appliance top surface
level with other surfaces.
WARNING!
You must install the anti-tilt pro-
tection. Install the anti-tilt protec-
tion to prevent the appliance to
fall with incorrect loads.
WARNING!
Your appliance has the symbol
shown on the picture (if applica-
ble) to remind you about the in-
stallation of the anti-tilt protec-
tion.
Make sure you install the anti-tilt
protection at the correct height.
Advertisement
Table of Contents
