Table of Contents
Advertisement
REVERSING THE DIRECTION OF ROTATION
The direction of rotation of the drill may be changed by the
use of the reverse lever (4) on the switch, situated above
the trigger. The position of this should only be changed
when the drill is at a standstill.
The reverse lever has two positions:
Clockwise rotation: Set the reverse lever to the right
position.
Anti-clockwise rotation: Set the reverse lever to the
left position.
Important
When hammer drilling, you do not need to force
the drill. Too much pressure will place
unnecessary load on the motor. Check the drill
bits regularly. Re-sharpen or replace blunt drill
bits.
Livetool Indicator
This tool features a Livetool Indicator
as soon as the tool is connected to the power supply. This
warns the user that the tool is connected to live power and
will operate when the switch is pressed.
Unplug the rotary hammer drill before making any
adjustment, servicing or cleaning the tool.
Keep your machine clean at all times.
Never use caustic agents to clean the plastic parts.
At the end of your work, to prevent dust deposits you
should use compressed air (max. 3 bar) to clean out
the ventilation slots.
Check the carbon brushes regularly (dirty or worn
carbon brushes result in excessive sparking and
After use, check the tool to make sure that it is in good
condition.
It is recommended that you take this tool to a Ryobi
Authorized Service Centre for a through cleaning and
lubrication at least once a year.
DO NOT MAKE ANY ADJUSYMENTS WHILE THE
MOTOR IS IN MOTION.
ALWAYS DISCONNECT THE POWER CORD FROM THE
TM
POWER SUPPLY BEFORE CHANGING REMOVABLE
OR CONSUMABLE PARTS LUBRICATING OR WORK-
(9) which illuminates
TM
ING ON THE UNIT.
If the supply cord is damaged, it shall be replaced by the
manufacturer or its service agent or similar qualfled
person in order to avold a hazard.
SAVE THESE INSTRUCTIONS FOR FUTURE REFER-
ENCE.
7
MAINTENANCE
Advertisement
Table of Contents
