Controls And Connectors; Front Panel - Behringer XENYX 1002B User Manual

7
XENYX 1002B User Manual
3.

Controls and Connectors

3.1

Front panel

(3)
(1)
(2)
(6)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
MIC – Plug a microphone into this input using an XLR cable.
(1)
LINE IN – Plug a line-level source into this jack using a ¼" TS or TRS cable.
(2)
INS(ERT)
– Plug an external dynamic processor into this jack using a TRS to
(3)
dual TS cable. You may also use the INSERT jack as a pre-EQ/pre-fader send
by plugging in a ¼" TS cable part way to the first click.
STEREO LINE IN
– Plug in a stereo source using two ¼" TS cables, or a single
(4)
line-level source using the left input jack only.
GAIN LINE – Adjusts STEREO LINE IN sensitivity, also known as "gain
(5)
setting."
GAIN MIC – Adjusts MIC input sensitivity, also known as "gain setting."
(6)
CLIP – Lights when preamp begins to overload.
(7)
PAN/BAL
– Adjusts the left-to-right positioning of the channel in
(8)
the stereo field.
HIGH
– Adjusts frequencies above 10 kHz by +- 15 dB.
(9)
MID – Adjusts frequencies peaking at 700 Hz by +- 15 dB.
(10)
LOW – Adjusts frequencies below 50 Hz by +- 15 dB.
(11)
MON – Adjusts the amount of signal sent to the MON SEND jack. This signal
(12)
is sent pre-fader.
FX
– Adjusts the amount of signal sent to the FX SEND jack. This signal is sent
(13)
post-fader.
CHANNEL FADER
– Adjusts the channel volume in the main mix.
(14)
(7) (4) (5) (16) (15)
2-TRACK OUTPUT – Connect to the inputs of recording device using
(15)
RCA cables.
2-TRACK INPUT – Connect to outputs of CD, tape or MP3 player using RCA
(16)
or ¼" cables.
PHONES
– Connect a pair of headphones with a ¼" TRS plug.
(17)
MAIN OUTPUT
– Connect to the inputs of a power amp or powered speakers
(18)
using ¼" TS cables.
FX SEND – Connect to the input of an external effects device using a
(19)
¼" TS cable.
MON SEND – Connect to the input of a powered monitor or monitor power
(20)
amp using a ¼" TS cable.
VU CLIP
– Lights when the MAIN OUTPUT signal begins to overload.
(21)
PHANTOM
– Sends 23V of power to the XLR MIC inputs for use with
(22)
condenser microphones. When used with batteries, 18V of power is supplied.
VU METER – Displays the MAIN OUTPUT signal level.
(23)
MON SEND – Adjusts the output at the MON SEND jack.
(24)
FX SEND – Adjusts the output at the FX SEND jack.
(25)
PHONES – Adjusts the output at the PHONES jack.
(26)
MAIN FADER
– Adjusts the overall output of the mixer through the MAIN
(27)
OUTPUTS. It also affects the signal at the PHONES out and 2-TRACK OUTPUT.
(21) (17) (18)
(19)
(20)
(22)
(23)
(24)
(25)
(26)
(27)