Front Panel Controls/Connectors; Controls And Connectors - Behringer XENYX 1002B User Manual

XENYX 1002B User Manual
3.

Controls and Connectors

3.1 Front Panel
– Plug a microphone into this input using an XLR cable.
MIC
[ 1 ]
– Plug a line-level source into this jack using a ¼"
LINE IN
[ 2 ]
TS or TRS cable.
– Plug an external dynamic processor into this
INS(ERT)
[ 3 ]
jack using a TRS to dual TS cable. You may also use the
INSERT jack as a pre-EQ/pre-fader send by plugging in a
¼" TS cable part way to the first click.
– Plug in a stereo source using two ¼"
STEREO LINE IN
[ 4 ]
TS cables, or a single line-level source using the left input
jack only.
– Adjusts STEREO LINE IN sensitivity, also
GAIN LINE
[ 5 ]
known as "gain setting."
– Adjusts MIC input sensitivity, also known as
GAIN MIC
[ 6 ]
"gain setting."
– Lights when preamp begins to overload.
CLIP
[ 7 ]
– Adjusts the left-to-right positioning of the
PAN/BAL
[ 8 ]
channel in the stereo field.
– Adjusts frequencies above 10 kHz by +- 15 dB.
HIGH
[ 9 ]
– Adjusts frequencies peaking at 700 Hz by +- 15 dB.
MID
[ 1 0]
– Adjusts frequencies below 50 Hz by +- 15 dB.
LOW
[ 1 1]
– Adjusts the amount of signal sent to the MON
MON
[ 1 2]
SEND jack. This signal is sent pre-fader.
– Adjusts the amount of signal sent to the FX SEND
FX
[ 1 3]
jack. This signal is sent post-fader.
– Adjusts the channel volume in the
CHANNEL FADER
[ 1 4]
main mix.
– Connect to the inputs of recording
2-TRACK OUTPUT
[ 1 5]
device using RCA cables.
– Connect to outputs of CD, tape or MP3
2-TRACK INPUT
[ 1 6]
player using RCA or ¼" cables.
– Connect a pair of headphones with a ¼" TRS
PHONES
[ 1 7]
plug.
5