NordicTrack T 5.5 Treadmill User Manual page 11

8. IMPORTANT: To avoid damaging the Pulse
Crossbar (31), do not use power tools and do
not overtighten the #10 x 3/4" Screws (13).
Orient the Pulse Crossbar (31) as shown. Start
one #10 x 3/4" Screw (13) with one #10 Star
Washer (11) into each end of the Pulse Crossbar
and each of the Handrails (71, 72). Then, start
another #10 x 3/4" Screw and #10 Star Washer
into each end of the Pulse Crossbar. Start all
four Screws, and then tighten them.
Insert the Console Frame (87) into the Handrails
(71, 72). Attach the Console Frame with four 1/4"
x 1" Screws (9). Start all four Screws, and then
tighten them. Be careful not to pinch the Upright
Wire (70).
9. Firmly tighten the two 5/16" x 1" Bolts (7) and the
four 5/16" x 1" Flat Head Screws (10) (only one
side is shown).
With the help of a second person, hold the con-
sole assembly near the Left Handrail (71) and
the Right Handrail (not shown).
Connect the ground wire from the console
assembly to the Console Ground Wire (89).
Next, connect the Upright Wire (70) to the
console wire. See the inset drawing. The
connectors should slide together easily
and snap into place. If they do not, turn one
connector and try again. IF YOU DO NOT
CONNECT THE CONNECTORS PROPERLY,
THE CONSOLE MAY BECOME DAMAGED
WHEN YOU TURN ON THE POWER. Then,
remove the wire tie from the Upright Wire.
8
87
13
11
9
71
70
9
Ground Wire
89
Console
Wire
70
11
13
11
9
31
72
Console
Assembly
Console
Wire
70
7
71
10
Wire
Tie