Renault 2013 Clio Cup User Manual page 30

98CUP_2013 Release
You must fit the wiring of the white connector directly on the plastic windscreen lower
grid using a tyrap® as indicated below:
The fire extinguisher is controlled by a deported control unit fitted on the central tunnel.
A specific fire extinguisher loom allows to link this control unit + fire extinguisher to the
chassis loom.
Position 1: system isolated
This position is to test the extinguisher loom. Everything must be correctly connected to
the loom. When you push the fire button (Facia switch panel or from outside deported
button), the green light must go ON but the extinguisher will not deploy.
NOTE : if the green light is ON without testing the system, there is a default on the
loom. In this case, you must be careful because the extinguisher is directly connected to
the command box. As a consequence, if you switch to position 3, you will immediately
deploy the extinguisher.
Position 2: battery check
If the orange light goes ON, the battery is ok.
Position 3: system armed
"System armed" means that if you push the fire button (Facia switch panel or from
outside deported button), you will immediately deploy the extinguisher.
The green light goes ON only when the extinguisher is deployed.
3
1
2
C-30
deported
control unit