B.6.4 Basic Procedures; B.6.4.1 P Ower - Up - Renault 2013 Clio Cup User Manual

98CUP_2013 Release
" Manifold P - def"
B
+ value in Blue
"Oil P - def"
B
+ value in Blue
"Water T - def"
B
+ value in Blue
"Throt FBW * def"
B
+ value in blue
"High press def"
B
+ value in Blue
"Low press def"
B
+ value in Blue
" V.V.T.1 - def"
B
+ value in Blue
"GB actuator - def"
B
+ value in Blue
"GB Pot - def"
B
+ value in Blue
"up contact – def"
B
+ value in Blue
"Solenoid R"
B
+ value in Blue
B "CBNT - Can Def"
B "Steering - def"
"Gear"
"Pit Limiter"

B.6.4 BASIC PROCEDURES

B.6.4.1
Power-up
Press the "ON" button of the facia switch panel (See B.6.1) to power supply the vehicle
The "COSWORTH" home page appears when the dashboard display first comes on, and
then moves to the first driver page (RACE Page)
B.6.4.2
Starting
Once the vehicle's electrics are on, flick the vehicle's "IGNITION" switch to the up (ON)
position.
Check that no gear is engaged (the letter "N" is displayed on one of the display screen's
driver pages).
Press on the "START" button without touching the Gas Pedal
The vehicle will only start if the following electronic equipments are connected
and are working properly:
- ECU
- CBNT
- Master relay
It is possible to start without plugging the dashboard
NOTE : For the first engine start after engine refitting, it's necessary to bleed the fuel
rail. To make it properly, please follow carefully the procedure indicated in chapter C-
Engine
1 Left Electrical fault on manifold sensor
1 Left
Electrical fault on oil pressure sensor
1 Left
Electrical fault on water temperature sensor
1 Left
Electrical fault on motorised throttle
1 Left
High pressure sensor default
1 Left
1 Left Intake V.V.T. servo control default
Gearbox actuator default (only if connected)
1 Right
1 Right Electrical default on barrel position sensor
1 Right Electrical default on upshift contactor
Electrical default on reverse solenoid (barrel
1 Right
-
- Major/minor fault on power steering module
Gear button pressed, message displayed in the
-
middle of the screen without alarm
Speed limiter enabled, message displayed on the top
-
C-22
Low pressure sensor default
unlocking)
CAN CBNT fault
of the screen without alarm
-
-
-
-
-
difference > 10°
between VVT1_tg and
VVT1_pos during
more than 5s
-
-
-
-
-
-
-