If The Machine Is Not Working - Electrolux EDC 3250 Instruction Book

If the machine is not working

Before calling out an engineer, please check through the details below because some faults can be rectified
easily without the need to call out an engineer. If service is called to resolve a problem listed below or to repair
a fault caused by incorrect installation or mis-use, there is a risk that you will be responsible for the cost.
Fault
G
The dryer will not start.
G
The load is not drying properly,
G
or is taking too long to dry.
The area around the dryer is hot.
G
The indicator lights flash in
G
sequence 1->2->3->4->1->2 etc.
Never attempt to repair the tumble dryer yourself.
Repairs carried out by unauthorised or inexperienced
persons can cause injury or serious malfunctioning.
This appliance complies with the requirements of the following EU directives:
– 73/23/EEC, dated 19.02.1973 – low-voltage directive.
– 89/336/EEC, dated 03.05.1989 (incl. amendment
92/31/EEC) – directive on electromagnetic compatibility.
Check
G
Is the door closed properly?
G
Is there power to the machine?
G
Has the fuse blown?
G
Have you set the program selector properly?
G
Is the water tank full?
G
Is the Start button pressed in?
G
Was right program chosen? Check that the
G
Reduced heat button has not been pressed.
Is the load too large?
G
Cotton
Synthetics
Is the fluff filter clogged?
G
Is the condenser clogged?
G
Was the load not spun enough in the washing
G
machine?
Has the door been opened while a program was
G
running?
Is the temperature in the room too high?
G
Must not exceed +35° C.
Is the room too small?
G
(Improve the room ventilation, open a door or
window, or choose another site for the dryer.
Is the program selector between two program
G
settings? Turn the selector to the setting required.
If this does not help, call service.
- 12 -
max. 3,4 kg
max. 1,5 kg