Electrical Connection; Changing Door Stop - Electrolux EDC 5372 User Information

Electrical connection

Details on mains voltage, type of current and the fuses required should be
taken from the type plate. The type plate is fitted near the loading aperture
(see "Machine description" section).
Important:
The plug must be accessible after the appliance has been installed.

Changing door stop

1
Warning! The door stop may only be changed by a specialist.
If necessary, please contact our after-sales service or your specialist dealer.
Warning! Before changing the door stop, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1.Open loading door.
2.Unscrew hinge A from the front of the
machine and take off the loading door.
3.Remove cover plates B and C. To do
this, insert a thin screwdriver into the
slots as shown in the illustration, press
downwards slightly and pry out the
cover plates.
4.Use an appropriate tool and exert
pressure to unfasten locking block D
from the snap-on fixture, take out and
reinsert on the other side having rotat-
ed the block through 180°.
5.Unscrew hinge A from the loading
door, rotate through 180°, reinsert on
the opposite side and screw down.
6.Reinsert cover plates B and C on the
opposite site having first rotated them through 180°.
25