Electrolux EDC 5372 User Information page 20

Problem
Drying results unsatis-
factory.
Loading door does not
open with DOOR (TÜR)
button.
Loading door does not
close.
When a button is
pressed, Err appears in
the multi-display.
Drum light does not
work.
PROGRAMME TIME
(LAUFZEIT) display
changes erratically or
stays unchanged for a
long time.
Programme inactive,
EMPTY WATER (BEHÄL-
TER) display illuminated.
20
Possible cause
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged with
lint.
Incorrect volume of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Mains plug disconnected.
Programme selector in OFF
(AUS) position.
Fine strainer not in place and/
or large mesh filter not locked
in place.
Washing protection. After the
start of the programme, the
option can no longer be set.
Programme selector in OFF
(AUS) position.
Defective light bulb.
Programme time is corrected
automatically depending on
type and volume of laundry
and level of dampness.
Condensate tank is full.
Remedy
Select a different programme the
next time you dry (see "Overview
of programmes" section).
Clean lint filter.
Clean heat exchanger.
Observe recommended loading
volumes.
Uncover ventilation slots in base
area.
Clean inside surface of drum and
drum ribs.
Make an adjustment using the
INTENSITY (RESTFEUCHTE)
function (see chapter "Drying,
Selecting additional functions").
Plug in at mains socket.
Set programme. Loading door
can be opened at any time by ex-
erting pressure on the door.
Install fine strainer and/or snap
large mesh filter into place.
Turn the programme knob to OFF
(AUS). Set the programme again.
Turn programme selector to
LIGHT (BELEUCHTUNG) or to
any programme.
Replace light bulb (see next sec-
tion).
Automatic process; this is not a
machine fault.
Empty condensate tank, then
start programme with START/
PAUSE button.