Changing Bulb For Inside Light - Electrolux EDC 5470 User Information

Condensation dryer
Table of Contents

Advertisement

Problem
Door cannot be opened with
the DOOR [TÜR] button.
Door cannot be closed.
Display shows: SELECTION
ERROR.
Drum light is not working.
Programme stops midway,
display shows: THE TANK IS
FULL, PLEASE EMPTY.
Drying cycle ends shortly after
programme starts. Display
shows: PLEASE CHECK THE
LOAD.
Washing is heavily creased.
Changing bulb for inside
light
Only use a special bulb which is designed specially
for dryers. The special bulb is available from the af-
ter-sales service, ET-Nr. 112 552 000-5.
1
Warning! Do not use standard bulbs! These
develop too much heat and may damage the
machine!
1
Warning! Before replacing the bulb, discon-
nect the mains plug; with a permanent con-
nection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this
can be found directly behind the loading aperture,
at the top; refer to "Description of machine" sec-
tion.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety,
the covering bonnet must be screwed down
tightly. If this is not done, the dryer must not
be operated.
Possible cause
Mains plug disconnected.
Programme knob in OFF (AUS) posi-
tion.
Fine filter not in place and/or large
mesh filter not inserted correctly.
The selected function cannot be
combined with other programme
settings.
Programme knob in OFF (AUS) posi-
tion.
Defective light bulb.
Condensed water container is full.
Not enough washing loaded or
washing loaded is too dry for select-
ed programme.
Possibly too much washing was
loaded.
Remedy
Plug in at mains socket.
Set programme. Door can be opened at
any time by exerting pressure on the
door.
Install fine filter and/or snap large mesh
filter into place.
Select another function.
Turn programme knob to LIGHT (BE-
LEUCHTUNG) or to any programme.
Replace light bulb (see next section).
Empty condensed water container, then
start programme with the START/
PAUSE button.
Select Timed Drying or higher degree of
dryness (e. g., INTENSIVE DRY
[STARKTROCKEN] instead of STOR-
AGE DRY [SCHRANKTROCKEN]).
Observe recommended loads.
25

Advertisement

Table of Contents
loading

Table of Contents