Changing Bulb For Inside Light - Electrolux EDH6370 User Information

Problem
Drying cycle ends shortly after
programme starts. END
(ENDE) display illuminated.
Drying cycle lasts an unusual-
ly long time.
Note:
After around 5 hours the dry-
ing cycle ends automatically
(see „Drying cycle complete").
Changing bulb for inside
light
Only use a special bulb which is designed specially
for dryers. The special bulb is available from the
after-sales service, ET-Nr. 112 552 000-5.
3
Important: When the appliance is switched
on, the interior lighting switches itself off after
5 minutes when the door is open.
1
Warning! Do not use standard bulbs! These
develop too much heat and may damage the
machine!
1
Warning! Before replacing the bulb, discon-
nect the mains plug; with a permanent con-
nection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this
can be found directly behind the loading aperture,
at the top; refer to "Description of machine" sec-
tion.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety,
the covering bonnet must be screwed down
tightly. If this is not done, the dryer must not
be operated.
20
Possible cause
Not enough washing loaded or
washing loaded is too dry for select-
ed programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room temperature.
Temporary switching off of the com-
pressor to avoid overload.
Remedy
Select time programme or higher drying
level (e.g. INTENSIVE DRY [STARK-
TROCKEN] instead of STORAGE DRY
[SCHRANKTROCKEN]).
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately spun.
Automatic process, there is no fault
with the appliance. If possible, lower
the room temperature.