Table of Contents
Advertisement
Electrical connection
Details on mains voltage, type of current and the fus-
es required should be taken from the type plate. The
type plate is fitted near the loading aperture (see
"Machine description" section).
The power supply cable must be accessible after installing the machine.
Changing door stop
1
Warning! The door stop may only be changed
by a specialist.
If necessary, please contact our after-sales
service or your specialist dealer.
Warning! Before changing the door stop, disconnect
the mains plug; with a permanent connection: fully
unscrew or deactivate the fuse.
1. Open loading door.
2. Unscrew hinge A from the front of the machine and
take off the loading door.
3. Remove cover plates B and C. To do this, insert a
thin screwdriver into the slots as shown in the illus-
tration, press downwards slightly and pry out the
cover plates.
4. Use an appropriate tool and exert pressure to un-
fasten locking block D from the snap-on fixture,
take out and reinsert on the other side having ro-
tated the block through 180°.
5. Unscrew hinge A from the loading door, rotate
through 180°, reinsert on the opposite side and
screw down.
6. Reinsert cover plates B and C on the opposite site
having first rotated them through 180°.
28
Advertisement
Table of Contents
