Yamaha XVS1100 Owner's Manual page 71

1. Ignitor unit panel
2. Spare fuse
3. Main fuse
3. Pull the ignitor unit panel outward
to the right.
Specified main fuse: 30 A
If any fuse is blown, turn off the main
switch and the switch of the circuit in
question. Install a new fuse of specified
amperage. Turn on the switches and
see if the electrical device operates. If
the fuse immediately blows again, con-
sult a Yamaha dealer.
PERIODIC MAINTENANCE AND MINOR REPAIR
CAUTION:
@
Do not use fuses of higher amper-
age rating than those recommend-
ed. Substitution of a
improper rating can cause extensive
electrical system damage and pos-
sibly a fire.
@
4. Place the ignitor unit panel in the
original position and install the
quick fasteners.
6-26
EC000103
After removal
fuse of
NOTE:
@
When installing a quick fastener, push
its pin back so that it will protrude from
the fastener head, then insert the fas-
tener and push the protruding pin in un-
til it is flush with the fastener head.
@
5. Install the rider seat.
Before installation
6