Yamaha XVS1100 Owner's Manual page 29

1. Quick fastener ( 3)
2. Mud guard
4. Remove the mud guard by remov-
ing each quick fastener.
INSTRUMENT AND CONTROL FUNCTIONS
1. Adjusting ring
2. Position indicator
3. Special wrench
5. Turn the adjusting ring in direction a
to increase spring preload and in
direction b to decrease spring
preload.
6. Make sure that the appropriate
notch in the adjusting ring is
aligned with the position indicator
on the rear shock absorber.
CI-15E
Stan-
Soft
dard
Adjusting
1 2 3 4
position
3-14
After removal
NOTE:
@
When adjusting, use the special
wrench which is included in the owner's
tool kit.
@
7. Install the mud guard and ignitor
unit panel.
NOTE:
@
When installing a quick fastener, push
its pin back so that it will protrude from
the fastener head, then insert the fas-
Hard
tener and push the protruding pin in un-
til it is flush with the fastener head.
5 6 7
@
8. Install the rider seat.
Before installation
3